Leveling Concrete Floor Before Epoxy

While shotblasting and chemical stripping are both effective methods of removing previous coatings from a concrete floor grinding has some notable benefits.

Leveling concrete floor before epoxy.

New slabs of concrete should be allowed to fully cure for 30 60 days before a coating is applied if a sealer was previously used on the concrete if water beads up on the surface do not use epoxy. Spray or pour the mixture on the floor to etch the surface then go over the floor with your power floor scrubber again. Note the caps and bold. Other solutions could be grinding the substrate or using epoxy grout to fill the substrate unevenness.

Before you install your new floor there s an essential consideration you need to address and that s moisture in the existing concrete floor. All concrete contains moisture and if the moisture level is too high it may cause the leveling compound to degrade over time. Repeat until the surface of the concrete has a gritty etched texture. This will not happen.

A common misconception is that by applying a high build epoxy coating like a self leveling on uneven concrete the floor will magically become smooth and level. Before an epoxy coating is applied to the floor jon don highly recommends considering the following. Grinding opens the pores in the.